top of page

Getting a Free EV Charger? What the Installation Actually Involves in Durham Region

Writer: James Barrett
James Barrett
Nov 12
6 min read

A growing number of companies will give you a Level 2 EV charger at little or no upfront cost, then pay you back for every kilowatt-hour you charge at home. The hardware arrives at your door. The installation does not. In Ontario, putting a Level 2 charger on your wall means a dedicated high-amperage circuit, a load calculation on your electrical panel and an ESA permit, and that work has to be done by a licensed electrical contractor.

Here is what that side of it involves, and what to think about before you sign up for any of these programs.


Why these programs exist

Canada's Clean Fuel Regulations let companies earn credits when electricity replaces gasoline. A single household cannot claim those credits. A company that aggregates charging data across thousands of homes can, and it sells them on the carbon market. That revenue is what funds the free charger and the cash back.

Several Canadian companies now run programs built this way. Grizzl-E Club, from Ontario manufacturer United Chargers, and the SWTCH Home Charging Program are two of the better known. These companies will provide you with the charger and make enrolling in the program seamless.

Other third-party monitoring and cashback providers work with smart, Wi-Fi-connected chargers from various brands. One example is Charge Lab Software, which connects to your charger through the Open Charge Point Protocol (OCPP).

If you drive a Tesla, then you can use Telemiq which is specifically designed to pull charge data from Tesla vehicles and will submit the data to the rebate program.

We expect to see more of these. As EV ownership keeps growing across Oshawa, Whitby, Ajax and the rest of Durham Region, so does the value of the credits these programs are built on.


What they tend to have in common

Keep in mind that specific rates and deposits change often.

  • The charger comes free or on a refundable deposit.

  • You are paid per kilowatt-hour charged at home, often at a rate that rises with use.

  • The charger stays connected to that company's network and needs the internet to report your charging.

  • There is usually no monthly or annual fee.

  • Installation is not included.

That last point is the one people are caught by, and it is the same across every program we have seen.


What to compare before you enrol


We do not recommend one program over another. These are the questions worth answering before you commit to any of them.

  • How much is the deposit, and what has to happen before you get it back?

  • What is the rate today, and does it rise as you charge more?

  • How much has to accumulate before you get paid, and how often?

  • Is the charger locked to that company's network, or can it be moved later?

  • What amperage is the unit, and which connector does it use? J1772 suits most vehicles from 2024 and earlier, NACS most from 2025 on.

  • What does the warranty actually cover, and for how long?

  • Does the program require professional installation? Some do.

Terms change, so check the program's own site for current figures rather than relying on any article, including this one.


The part no program covers

A Level 2 EV charger is not an appliance you plug in and forget. It is a dedicated high-amperage circuit, and in Ontario it is work that requires notification to the Electrical Safety Authority and an inspection. A free charger does not change any of that. The electrical work is identical whether the unit costs you nothing or six hundred dollars.

Here is what an installation actually involves in a Durham Region home.

Your panel comes first. A Level 2 EV charger draws continuously, so it requires a properly sized breaker, wire and a panel with the capacity to carry it. Plenty of homes in Oshawa, Whitby and Ajax built before the 1990s still run on 100A service that is already carrying a stove, a dryer, central air and sometimes electric heat. Adding a charger on top can exceed what the service will support. A load calculation answers that question, and it is the first thing we do. We will ask you to request a one year hourly historical usage data from your utility. With this data we can determine if your electrical system is at risk of being overloaded.


There are usually three outcomes.

  1. The panel has capacity and room for the breaker. This is the straightforward case.

  2. The panel is close to its limit, so the charger is derated or load management is added.

  3. The service needs upgrading, typically to 200A.


Derating is the option most homeowners have not heard of. Most Level 2 EV chargers can be set to draw less current than their maximum. A charger running at a lower amperage still refills a typical daily commute overnight, and it can let a home avoid a full service upgrade. The most common size of EV charger installs are 48 amp. But most chargers can also be derated to lower values like 40 and 32 amps. It is worth asking about before you assume you need a new panel.


Then the practical details. How far the charger sits from the panel, whether the run passes through finished space, whether the garage is attached or detached, and whether any of it runs outside. These drive the labour more than the charger does.


Finally, the permit. Electrical work of this kind requires ESA notification and inspection. We handle that as part of every installation. We complete the work, apply for ESA permit and after inspection we provide the homeowner with the ESA certificate.


Watch an installation from start to finish

This video shows the installation of a 48-amp Grizzl-E Ultimate Level 2 EV charger in Oshawa. The wiring was run from the main electrical panel through the basement above a finished drywall ceiling. After the wiring was installed the hole in the drywall was sealed with expanding foam and drywall compound to provide an airtight seal and a clean finish look.


Questions we get asked

Do I need a permit to install an EV charger in Ontario?

Yes. A Level 2 charger installation requires notification to the Electrical Safety Authority and an inspection. A licensed electrical contractor files this as part of the job.


Will my electrical panel handle an EV charger?

It depends on your service size and what is already connected to it. Many 100A homes can take a charger, particularly a derated one, and many cannot. A load calculation is the only way to know, and it takes an electrician a short visit.


Do I need a 200A service for an EV charger?

Not always. A service upgrade is one of three possible outcomes, not a default. Plenty of homes take a charger on their existing service, sometimes by running it at a lower amperage. Get the load calculation before you budget for an upgrade.


Can I install the charger myself?

If you already have a properly rated receptacle on a dedicated circuit, mounting a plug-in unit is straightforward. Installing that receptacle, or hardwiring a charger, is electrical work that requires a permit and inspection. Some programs also require professional installation as a condition of membership.


How much does EV charger installation cost in Oshawa?

The cost of installing a Level 2 EV charger in Oshawa can vary considerably depending on the electrical set up of your home and the installation requirements.

As a general guideline, a straightforward level two EV charger installation may start around $700-$1000, while more involved installations can range from $1000-$3,000 or more.

Some of the main factors that influence installation costs include:

  • Distance between your electrical panel and the charger.

  • Available electrical capacity and whether load management is required.

  • Accessibility of wire routes.

  • Whether electrical panel modifications or upgrades are needed.

Every home is different. Barrett Electric provides an assessment and a clear quote before work begins, so you know exactly what is involved and what to expect.

Contact us for a quote on your level two EV charger installation in Oshawa and the Durham region.


Which program should I choose?

That is your call, and the terms move around enough that any recommendation would date quickly. Work through the comparison questions above, then check current terms on each program's own site. We install chargers from any of them.


Will Barrett Electric install a charger I got through one of these programs?

Yes. We install any make of Level 2 EV charger, whether you bought it, received it through a program, or already have one on the wall. We are not affiliated with any program and have nothing riding on which one you pick.


Thinking about a charger in Oshawa, Whitby or Ajax?

Whichever program you choose, and whether you choose one at all, the charger still has to go on the right circuit, with the right breaker, under the right permit. Barrett Electric is a licensed Master Electrician serving Oshawa and Durham Region, and we handle load calculations, panel upgrades, charger installation and ESA inspection.



Not sure your panel can take it? Call us at 905 431 8020. We will tell you straight, including when running the charger at a lower amperage will do the job without a service upgrade.

Comments


Commenting on this post isn't available anymore. Contact the site owner for more info.

CONTACT

Barrett Electric Inc.

Oshawa, Ontario


James Barrett

Direct Line: 905-431-8020

james@barrettelectric.ca

​

ECRA License # 7007415

AREAS COVERED:

 

Oshawa

Whitby

Ajax

Courtice

Brooklin

  • Facebook
  • X

DROP US A LINE

Send us a message to tell us about your specific electrical issue, installation need or problem. We'll be back in touch with you as soon as possible!

Your details were sent successfully!

© 2026 Barrett Electric  Inc. | Oshawa Electrician

bottom of page